Petrus's Profile
Hello everyone:
I have recently changed the scope base on my Remington 700P, in order to install a better one. When removing the old one, I noticed a little marring on the receviver, just in some of the places that the scope base makes contact. ¿Is this a normal thing, and I should not be worried about? After intalling the new one, the marring is not visible, as it´s in the inside.
Greetings from Pedro (Spain).
-
- Advertisement
Marring on receviver, under scope base
Moderators: Scorpion8, ripjack13, John A.
7 posts
• Page 1 of 1
 Posted: Mon Sep 14, 2015 2:20 pm
|
|
|
Posted: Mon Sep 14, 2015 3:53 pm
Nothing to worry about...especially if it can't be seen now.
|
|
|
Posted: Tue Sep 15, 2015 3:00 am
Thanks a lot for your reply. But can it be considered something that usually happens?
Greetings |
|
 .270 WIN
Posts: 302
Joined: Fri Dec 19, 2014 6:31 am Location: Williamsburg, Va. |
Posted: Tue Sep 15, 2015 5:43 am
Yes. There is not a 'perfect' fit of the mount to the receiver, and it will move very minimally under recoil, thus leaving a mark. Another reason why you should re-tighten/check the scope mount screws routinely.
What could have happened... did.
|
|
Posted: Tue Sep 15, 2015 11:01 am
^^...What Virginian said... ^^
|
|
|
Posted: Tue Sep 15, 2015 11:35 am
Thanks a lot, and greetings from Spain
|
|
|
Posted: Wed Sep 16, 2015 10:13 am
No problem...
|
|
7 posts
• Page 1 of 1
Return to Firearm Maintenance, Modification, Safety And Troubleshooting
Who is online
Users browsing this forum: No registered users and 1 guest
-
- Advertisement
The team
Delete all board cookies• All times are UTC - 5 hours Powered by phpBB© 2000, 2002, 2005, 2007 phpBB Group
