1100 trigger mods.
Moderators: Scorpion8, ripjack13, John A.
5 posts
• Page 1 of 1
Has anyone tried the Timney "trigger fix" for improving the trigger pull on the Remington 1100/870 shotguns.
JJK
|
|
Don't own a 870 / 1100...so sorry, can't help you there.
|
|
Went ahead and did it. Installed the lightweight spring and ended up with a very crisp pull just under 2lbs.
It's a pain to install as you have to remove the carrier assembly to get to the back side of the sear pin to push it out. JJK
|
|
Just did a couple. Worked out fine with a nice light trigger pull. Reassembly can be tricky with the spring and holder under pressure, had them flying all over the place. Finally used a rubber band to hold them while I assembled the pawl, then cut the band and pulled it out. Probably several better ways to do it.
|
|
How about just installing a new spring. Not one from many of the parts houses. They are all around 4-6 lbs. I finally gave up in disgust and had some manufactured. http://springs.ccskeet.com mailto:springs@ccskeet.com
|
|
5 posts
• Page 1 of 1
Return to How To's and Modifications
Who is online
Users browsing this forum: No registered users and 0 guests