Remington 1100 problem
Posted: Fri Aug 10, 2018 8:40 pm
After shooting +-75 rounds out of my 1100 at the skeet/trap range i took it home for a deep clean because the universal Winchester loads left my shotgun filthy. After disassembling the shotgun and cleaning it, I went to assemble it. Much to my surprise the small takedown pin that drives through the receiver and trigger assembly would not drive all the way through. I pulled it out and looked in the receiver to see the bolt release leaver (the leaver that is pushed in to pull the bolt from the receiver) slid over half of the hole, stopping the pin. Do y’all have any suggestion on how to move this? I tried driving it back with a mallet but that thing is stuck.