I recently purchased a torque screwdriver and want to use it to torque the receiver screws before re-sighting after installing a new scope. The rifle is a BDL in .223, free-floated barrel, glass-bedded action. I haven't been able to find any information on how many inch-lbs I should set on the device.

I know that I can start low (20?) and work my way up as I shoot groups, and then back off when they start to spread. However, this would use up a bit of ammo and time, neither of which I have much of to spare.

So, if you can advise me as to what setting(s) have worked best for you, I would appreciate your input. Thanks for your time.

Ed

Welcome to the Remington Owners Forum Ed !!

Sorry...can't help with that spec...but I'm sure some member here will be along with a reply.

Hang tight...

Go here, different specs for different scopes, mounts, rings and basses.
http://www.opticstalk.com/torque-specs_topic18389.html
I normally go 15-20 inch pounds.